Soundsgood beta 1.0.2.r615

[yogi]

i've just upgraded to the latest beta to avoid that crazy scanning bug only to realize that now
the volume on my usb speakers dropped to ~ 20% of the version before, where i had the volume
set to a bit below half of the volume bar.
now on the new beta i can hardly hear anything at 100% volume ...

can anybody confirm that?
any solution to fix it or is it just the new bug?

[Kerry]

I do not have USB speaker but through my amplifier, the volume is quite okay with the beta version of soundsgood.

[yogi]

nope i mean direct attached to usb port, in my case 608t

[Kerry]

Yes I know, using amplifier through HDMI or USB speaker are just means of the local output of soundsgood. The volume control is still in soundsgood and amp or usb speaker. You may check if the volume in soundsgood is adjusted to the top.

[yogi]

so i rolled back to the official r546 version and volume level is fine again,
must be some bug in the beta ...

[yogi]

today's update to r618 unfortunately did not solve my problem,
still volume usb output much too low ...