The settings file for NZBGet (admin user) is not being saved to the correct folder.
At app install, and NAS bootup, the settings for NZBGet appear to be being read from the following folder:
Code: Select all
/volume1/.@plugins/AppCentral/nzbget/config/nzbget.conf
However, once changes are made within the NZBGet UI, and "Save All Changes" is selected, the settings are saved to a new file located at:
Code: Select all
/volume1/.@plugins/AppCentral/nzbget/nzbget/nzbget.conf
This then results in the incorrect settings file being loaded on a clean boot of the NAS. If a reload of the UI is performed (i.e from the SYSTEM -> Reload) option, the settings appear to be being read from the file located in the second folder. However if booting clean, and any changes are made, this will replace the one in the app folder with the one from the config folder plus the changes you've made to this point from the default config folder, thus wiping out any extensive changes made up till that point. Will also result in settings regression to defaults upon a NAS reboot, because the (now) incorrect stock config file is being used.
I'm assuming here that there ought to be a symlink in place here pointing from the app folder to the config folder so saved settings are redirected to the "config" folder. This is not occurring for me with this version of the addon.
Tested on: Asustor AS5104T
Firmware: 2.4.2.RIG1
NZBGet Version: 15.0
Addon Version: 20150706
Dan / Gib.