Hi guys,
I was hoping to get some help on this.
I've got an AS-302T. It had 2 x 1Tb WD RED hard drives attached, in RAID 1.
Now, this past weekend I did an upgrade to 2 x 3Tb WD RED hard drives. The initial replacement speeds were pretty good, averaging 110MB/s.
Although after replacing both hard drives and hitting the expand button, there is another sync in progress and the speed will not go above 6MB/s. Sometimes even dropping down to 2MB/s.
The system is not being accessed and I was hoping to find out if it's possible to increase this speed?
Any help would be much appreciated. Thank you
Upgraded Drive Capacity - Sync speed really slow after hitting Expand
Moderator: Lillian.W@AST
-
- Posts: 1
- youtube meble na wymiar Warszawa
- Joined: Tue May 02, 2017 2:58 am
-
- Posts: 917
- Joined: Fri May 15, 2015 1:56 am
Re: Upgraded Drive Capacity - Sync speed really slow after hitting Expand
You won't get the speed back up until the drives are synced and the increase capacity job is finished. This could take a while.
- orion
- Posts: 3482
- Joined: Wed May 29, 2013 11:09 am
Re: Upgraded Drive Capacity - Sync speed really slow after hitting Expand
You can refer to the following:
viewtopic.php?f=27&t=3499
viewtopic.php?f=27&t=8156&start=10
You'll need to use ssh to login to NAS to execute the command.
viewtopic.php?f=27&t=3499
viewtopic.php?f=27&t=8156&start=10
You'll need to use ssh to login to NAS to execute the command.