Page 1 of 1

EZ-Router setup doesn't works

Posted: Fri Sep 06, 2019 1:36 am
by DonWhite
Hey guys,

I'm new here so pls be honest :o
I have the following problem with my Asustor NAS(AS6204T):
Yesterday I had to reset my Router(Fritzbox 6490) to factory settings and since then the EZ-Router Setup and the Port-forwarding function between the devices doesn't works.
If I pushing the Activate button on the ADM\settings\Manual connect\EZ-Router tab, I'm getting the following message:
"Multiple routers detected. The router's external IP is different than the NAS's external IP. Please check your network environment first."

I'm deep in the dark now with this, before my router reset I haven't had this issue. Unfortunately i Cannot find any Infos about this.
The other functions like Easy-Connect, DDNS, etc. seems to be working fine.
The NAS\Router is running on the latest update.

Thanks for any help in advance!

Don

Re: EZ-Router setup doesn't works

Posted: Fri Sep 06, 2019 10:19 am
by orion
It might be caused that you set external IP on your router correctly before. I guess you asked your ISP to provide a public IP for you. So, simply set the original external IP on your router.

Re: EZ-Router setup doesn't works

Posted: Tue Sep 17, 2019 1:28 am
by DonWhite
Hi orion, thanks for the response!
Somehow I haven't got any notifications about your message.

It turned out a Fritzbox factory setting caused the problem.
After a while I've found out that the setting in the Router's menu "use IPv4 over IPv6" has became "turned off" due to the factory reset.
I've turned it on and then the NAS's EZ-Router support was able to set up itself immediately.

Cheers!