It is currently Mon Jun 24, 2019 9:13 pm
All times are UTC + 8 hours

[SOLVED] Probem for correct syncing

The hubiC cloud storage service has a large user base in Europe. Using DataSync for hubiC allows users to easily connect to their hubiC accounts and perform data backup.

[SOLVED] Probem for correct syncing

Postby rezza » Wed Apr 05, 2017 9:24 pm

Hello,

My synchronization is from NAS to Hubic only.
The sync is finished (same data volume on each side).
Yet, my hard drives are constantly working.
The Hubic process typically takes 2% CPU and usually take 100 MB of RAM but sometimes more.
Hubic indicates permanently "indexing remote files" or "searching for modification".
This makes the NAS work unnecessarily and prevents (I think) standby.

Would anyone have the same problem as me?


Thanks in advance.

RezzA
Last edited by rezza on Thu Apr 13, 2017 7:44 pm, edited 1 time in total.
rezza
 
Posts: 11
Joined: Wed Apr 05, 2017 8:48 pm

Re: Probem for correct syncing

Postby rezza » Wed Apr 12, 2017 4:32 pm

Hello,

Here is an extract from the hibernation report S3:

The following processes are continuously accessed from the hibernation. You can manually close these processes.
Hubic.cgi
Dropboxd
Transmission-da
Smbd
Logmand
Apache2


Concerning the 1st (Hubic), the synchro is however paused ...

How to force these processes to close to allow a S3 standby?

Thanks in advance.
rezza
 
Posts: 11
Joined: Wed Apr 05, 2017 8:48 pm

Re: Probem for correct syncing

Postby orion » Thu Apr 13, 2017 11:16 am

It seems that there many tasks still running, rather than hubic only. Some of them seems mandatory. It's not a good idea to kill them forcefully. If you intend to put NAS into S3 manually, you should go to ADM web page, then select "Sleep" menu.
User avatar
orion
 
Posts: 2264
Joined: Wed May 29, 2013 11:09 am

Re: Probem for correct syncing

Postby rezza » Thu Apr 13, 2017 7:43 pm

I am changing my way of managing my NAS :

I am activating Apps only when needed and schedule a near permanent S3 sleep state.

I am a bit disappointed that the automate S3 mode (minimum 30 minutes with no disk access) seems to be impossible to reach with a "normal" NAS usage...
rezza
 
Posts: 11
Joined: Wed Apr 05, 2017 8:48 pm

Return to DataSync for hubiC

  • You cannot post new topics in this forum
    You cannot reply to topics in this forum
    You cannot edit your posts in this forum
    You cannot delete your posts in this forum
    You cannot post attachments in this forum
  • Who is online

    Users browsing this forum: No registered users and 1 guest

cron