ASUSTOR Community Forum

Hello.
I have a NAS AS6202T and I think I have some problems with it.
NAS does not boot properly, I can not access it.
But once I get it, I can not save any settings.
On NAS after starting, the green LED blinks.

I replaced the power supply, but did not help.

what could help:
Downgrade ADM?
Maybe install a new BIOS?

I would have asked for advice on this problem with NAS

I suggest you create a ticket at https://support.asustor.com.

They should be able to help you sort out what the problem is.

How did that happen?

Was an ADM upgrade or auto-upgrade that caused it?

What was the last known working (properly) ADM version?

I am running latest version of ADM on a AS6202T with no problems. Not sure what would cause what the OP has described, perhaps some sort of corruption, or maybe even a drive failing? If you can get in I would definitely start running Dr Asustor, as well as Disk doctor.

You may determine if it's caused hardware (or internal firmware) or content in disks:

• Power NAS off.
• Remove all of disk.
• Power NAS on.
• Can you hear a beep sound and find NAS by ACC software after NAS boots up? If it works, that means the content in disks is corrupted.

I sent the device to the service, But thanks for trying to help me.